Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Throw this storage cover over your fifth wheel to protect it from rain and snow while you're storing it in between camping trips. The cover secures with the integrated straps and adjustable tension panels so it won't flap in the wind.
Features:
Specs:
You're worried about your fifth-wheel toy hauler getting wet and dirty in storage before your next camping trip. Whether you're storing your fifth wheel in the rainy northwest, snowy north, or humid south, this weather-resistant cover is designed for use in extremely wet climates so your fifth wheel will be protected. When you keep your fifth wheel covered, you are less likely to need to wash and wax it in between trips. And if you want to trade your fifth wheel in for a newer model later down the road, this cover will help maintain that resale value.
The 3-ply PolyPro top panel has moisture-wicking technology that vents condensation away to reduce moisture buildup that can damage your fifth wheel over time. It also beads water when it rains to stop it from pooling or freezing, which eliminate the black streaks and corrosion you tend to see on the sides and roof of your fifth wheel. And when the rain stops, the fabric dries quickly in mild sunlight to minimize the development of mold and mildew.
How to Measure Your Fifth-Wheel Toy Hauler
To determine if this cover will work for you, measure the overall length of your fifth wheel from the very front to the rear bumper, making sure you're accounting for any spare tire carriers and ladders on the back. The cover isn't meant to fit over the kingpin of your fifth wheel, so don't include it in your measurements. Then measure the overall height from the bottom of your fifth wheel to the top. Do not include any AC units, vents, or antennas in your height measurement, as the cover is already designed to accommodate them.
Securing the Cover onto Your Fifth-Wheel Toy Hauler
The included ladder cap helps prevent the cover from splitting on that area of the fifth wheel so install it first. Then unroll the cover and carefully spread it evenly around your fifth wheel, making sure you don't pull too hard and tear the fabric. When you're putting the cover on your RV, the brand logo should be positioned at the front of your rig.
Once the cover is in place, wrap the elasticized hem on the cover around the bottom corners of your fifth wheel to remove any excess slack in the material. Adjust the tension panels on the front and rear of the cover with the ropes until the cover fits snugly around the contours of your fifth wheel. Then secure the cover with the integrated straps to prevent it from flapping in the wind and damaging the paint job. The tension panels will help reduce the stress on the cover while you're tightening the straps.
And if you still need to winterize, you can use the zippered panels on the passenger's side to easily access the interior of your fifth wheel without having to completely remove the cover.
Average Customer Rating: 4.3 out of 5 stars (345 Customer Reviews)
Throw this storage cover over your fifth wheel to protect it from rain and snow while you're storing it in between camping trips. The cover secures with the integrated straps and adjustable tension panels so it won't flap in the wind.Terrible! Ripped after a month of use. Would not recommend.
Thanks for reaching out after 1-year. To be honest I've been wanting to reach out for several months but didn't want to hassle with CS. I believe the cover itself is protective and does it's job. The problem I've had is all the securing straps have ripped off (with light wind) and now in order secure the cover I've had to create my own tie-downs and it's not working that well. The secure points are weak and if they go it's almost impossible to use. I will update with specific photos
Jenny N.
4/28/2022
I will have our Customer Service team reach out to you. The cover does have a limited 3 year warranty.
This cover only lasted one winter. When I went to remove cover it was ripped on top by both air conditioners, antenna and vents. Seems they need to use a better quality material on the roof area. But Classic Accessories customer support backed up their warranty by sending us a replacement cover for free.
Advertised to fit up to 44' but missed fitting my 44' 2020 Rapture 5th wheel by 6". Since this was the longest I could find, I just left the back flap unzipped and tied down. This lasted about 9 months and it ripped down the length. I have had one previously with a different RV that lasted 3 winters.
The 5th wheel cover seems to be made very well. The only issue is you have no idea which is the front or back when you first get it and try to put it on. There were no instructions, not that there really should have been but would have been nice for new customers.
Overall the cover is good. The only issue we have is that the manufacturer did not consider extended down spouts which made the cover fit extremely tight. We had to put a hole on each side to accommodate the down spouts. The cover went on quickly and all in all is good.
Cover works very well. It is somewhat awkward to take off and put on due to size. Once on, it does a great job of protecting rv from elements. After one year, cover is showing minimal wear and tear.
Well made and should last years. Happy with the purchase and the people at Etrailer were super to work with.
Great service as always!!
Richard
3/23/2022
We cover our rv all summer when I removed it last fall the rv was clean it worked great
Great experience dealing with etrailer on getting a High quality cover that fits perfect over my tada travel trailer
This cover seems well constructed and fairly easy to put on the trailer. However, it wasn't folded to apply the way the instructions stated. As well, the instructions say to get on top of the trailer, which we aren't able to do. My suggestion is to change the instructions. It took two of us -- we spread out the cover, then on each side walked the cover back and over. Doing it that way wasn't too hard. Suggest putting pool noodle sections on the trailer parts that are pointy and stick out. Glad we got it!
So far so good . I was afraid that this would not fit my popup. I have a Rockwood Highwall the big one. and it fit just fine with little extra room. Just what I needed. Thank you very much.
Well crafted and sturdy. Fit Ram chassis Thor perfectly. The cover was thoughtfully constructed: during storage it’s easy to open for RV access (without having to undo the entire cover); came with throw bag” for use is getting tie straps under the coach; zippers and ties are all secured well. Wish only that there was a note about “front” so my first installation didn’t have to be turned around…
Rather than the convenient webbing and Fastex buckles that were provided on my last cover, Classic Accessories gave me three pieces of cheap, slippery rope for tie downs. It provided the opportunity to practice my knot tying skills while lying in the mud under my trailer. This will be my last Classic Accessories cover.
Fits well on our Flagstaff Aframe popup including our front toy hauler rack. However the back corner developed small tears on the initial fitting. We have reinforced those corners. We like the heavier ceiling material & that it is white which will reflect heat/sun/ UV rays better. We also like the 4 vents hidden under a flap (2 on each side) - that should help reduce over heating and moisture build up plus reduce wind damage. Rather than use the rope they supplied as tie-downs, we have attached strapping & clips for the front, back & to the 3 side tie-down locations. The storage bag is nice to have, although it should be larger. We hope the cover will last 2-3 seasons
Just finished putting the cover on our pop-up trailer and it fits perfectly. Looks great. We have put a lot of time into restoring our old camper-lots of memories in there-and wanted to be sure it stayed nice and dry thru the winter. We are very pleased with your product and how easy it was to install also. Would definitely recommend to anyone looking for a cover for their trailer. Hoping to see the inside of the camper is nice and dry in the spring.
This fits a 1957 Shasta 1400 exactly. It has a 3 year warranty, which is exactly how long my last Classic cover lasted before the wind tore it. However, this was at high elevation (7000 ft) with strong sun and high winds (30-40 mph regularly) as well as cold winters (well below zero frequently). I expect it would last longer in more gentle conditions. I will continue to replace with the same cover every 3 years.
I really liked this product. I was replacing an older cover that lasted about 4 years. This cover is a better quality and construction, and it looks like it will protect my travel trailer well. Also, I received the cover very quickly after ordering it. I recommend etrailer.com for their service and the quality of their products.
Its excellent... So far... I just put it on. It went on extremely easily and I did it alone. Instructions say two people, but I found it simple to do myself. I'm also OK with walking on my camper roof. I feels well made. Time will tell if it survives a New England winter.
Seems well made and as advertised. Went on easily with good elastic at the corners. Nice length on the sides. I ordered the 20 foot for a Trailmanor 2619 and have plenty of length at the front and rear.
While this is a custom cover meant for the small r-pod trailer, I purchased it for our ProLite Mini 13 based on recent reviews from others with the same trailer.
I was very pleased to see that the material and construction quality was similar if not identical to a number of excellent and durable covers I’ve used to store non-winter driven sports cars. However, the installation process was challenging for a number of reasons.
Firstly, after reading the Classic Accessories guide that instructed to unfold the cover from front to back on the roof of the trailer, I found that the manufacturer had folded and packed the cover incorrectly. Specifically, the cover was folded side to side instead of front to back, i.e.: the white roof section appeared at one end of the completely unfolded cover instead of appearing in the middle as expected. That meant we had to completely open up the cover on the roof of a car and manhandle it into place on the trailer after locating the yellow “front” label. The trailer is stored right next to our garage, so this task was not fun. We expected some fitment issues from a custom cover intended for something else, but not a packaging curve ball.
Secondly, (and I kick myself for not having noted this before we even started) the front and rear side profile contours of the r-pod are essentially the opposite of the ProLite Mini. So, not surprisingly, the “normal” fitment was unsatisfactory. After pulling and stretching to no avail, we still would have had poor rain runoff and unwanted Michigan snow buildup in loose folds at the at the front. So, we removed the cover and rotated it front to back for an almost perfect fit. It’s somewhat tight at the front and loose at the back, but much weather resistance than our first attempt. The only downside is that the zippered door section is now on the opposite side of the trailer, but it’s not a big issue for us.
As a sidebar, I’ve wondered why RV cover companies have neglected offering custom fitments for the Roulette ProLite line of Canadian trailers. Their market volume in the US and Canada is significant, and the weather conditions in Canada suggest a worthwhile sales rationale.
Very pleased overall. Easy for two people to install, remove and store. We did add a few extra tie down ropes to secure the part protecting the front that overhangs the truck cab. Rig was stored outside and we were concerned wind could blow it off.
I have a 2017 Mini Winnie Drop 1790. Wanted a cover for the winter months to keep it looking great. Stumbled upon etrailers website but couldn't find a cover exactly for my trailer. Used the ask a question link and got a very prompt response. That was awesome. The email said this cover was for a R Pod but should work. It fits well except the left side where the plug in is located. I keep it plugged in at home to run the fridge. We had a pretty decent wind storm the other night and the cover didn't budge. Was about a 10 minute install with me and my wife with a couple step ladders. The zippered door opening match up nice for the door and rear hatch. Overall, great customer service and what looks to be a great product!
Do you have a question about this RV Cover?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Katrina B.
5/9/2023
I see that this item has a 3 year warranty. I have sent your information over to our customer service department for them to assist you.